Learning How to Change Coil in Vaporizer

Myle V4 Pod Kit

How to change coil in vaporizer is a topic that is being asked by many people who are really interested in making their Vaporizers last longer. When you buy a new Vaporizer, it comes with a coils. There is nothing wrong in replacing the coils as it makes the device better in terms of performance and longevity. So, if you are looking for some pointers on how to change coil in Vaporizer Smokus, then read through the following information.

 

One of the tips to follow when you want to change coil in Vaporizer Smokus is to avoid heating the coils above 150 degrees. This is because heating up the coils will affect the wick material. The material of the coils absorbs heat energy when it is heated and this energy will then be radiated to the smoke chamber. If you want to change coil in vaporizer, then it is advisable that you do not exceed the temperature of the heating element.

Another tip on how to change coil in Vaporizer Smokus is to clean the heating plate. It is very important because the plate is where the wick is placed and it absorbs heat energy from the heater. If the plate is dirty, then it will hinder the radiance of the heat and it might even cause the coil to break down. Therefore, you have to clean it regularly.

If you want to know how to change coil in Vaporizer Smokus, then it will be better for you if you remove the heating element from the unit. Then, you can use a gentle cleaner such as the Baby Kutter Oil-Washable Spray Cleaner to wash off the plate. You can do the cleaning with the soft cloth. When doing the cleaning, you need to make sure that you are doing it properly to prevent any damage or spillage. In addition, when you are cleaning off the plates, you have to be careful in removing them so that you won’t be damaging the coil.

Thirdly, you have to take out the mesh screen from your Vaporizer Smokus. If you are going to replace the mesh screen, you have to make sure that you choose the right size that will fit your Vaporizer. In addition, you have to see to it that you are going to put the screen in the right position. By doing those things, you can get the following tips on how to change coil in vaporizer.

Before you are going to remove the mesh screen from the Vaporizer, you have to unplug it first. Also, you have to turn off the power at the main switch in your house. After that, you can take out the wire that is attached with the base unit. In this case, you have to separate the two coils by pulling them out. In this case, you have to be careful because if you pull it too much, you might get your hand hurt.

Fourthly, you have to locate the coil already. When you are removing the base unit, you must be very careful in holding it because it has a tendency to fall off if you are not careful enough. However, you can use tweezers and push them carefully. When you are about to remove the base of the Vaporizer, you can use the screwdriver to release the screws that hold it together. So, you can learn how to change coil in vaporizer easily.

Fifthly, you need to find the area where the coil is located. It means that you have to disassemble the Vaporizer base by loosening the screws and separating the base and the coil. Meanwhile, you can put back the base of the Vaporizer and then you can turn on the power to check whether the coils are already separated. Then, you can place the two pieces of the base in opposite sides of the base and you can tighten them. Finally, you can replace the base of your Vaporizer in the same way as how to change coil in vaporizer.

Leave a Reply