Anthony Vapes: Advken Manta RTA Review

Hi all, Anthony woozy back here with my Advken Manta RTA. Warning: This product was sent to me from elementvape.com

 

comments Disclaimer

I review the products for what they do not take into account where it comes from or who made it. The results of the test results for what is in my hands. Due to possible differences QC your experience may be different. I spent more time with the product and then most of the criticism and try to be thorough, making disassembly to check faulty design, test accuracy, and stress testing, which is usually done in the ‘care industry to try to “force” the failure diagnosis or potential failure point to give me an idea of ​​the life of the product. That said, there is no way to predict whether or device will last 6 months, 1 year, 5 years, etc. Each item is produced from cars to cell phones to computers pods may have arrived DOA or a small% failure rate. There is no way to predict or quantify it. That’s why there are guarantees and lemon laws. I can look at what I have in my hands for better or worse. Contrary to popular belief, there is no special review samples of top quality. Most of my personal time to get the commercial version, sometimes I get their initial version is usually worse than the final retail version.

 

Introduction:

Manta RDA is the last Advken. They are a company that has been around for a while, but with little fanfare. Most popular products, they can gorge mad hatter GDR and with a gap on the hinge for easy filling. Manta part double coil air flow RTA with a capacity of 4.5 ml with glass bubbles (or 3 ml of capacity with ordinary glass) and is available in 5 colors, black, SS, rainbow, blue, and gold.

 

Manufacturer Specifications

Staniless 24mm stainless construction

gold plated double bend Post and Central Bridge Section Section

Top Re-filling system

setting tri-water-holes system

510 wire and gold plated contact pin

CHUBBY standard glass tube parts and normal glass tubes

4.5 ml / 3 ml capacity According tube Choice

Coming up with a screwdriver and Confederate bag

Standard gift box package

Included in the box

1 Blanket 24mm RTA

Bubble extensions Cristal 1

1 roll screwdriver Dr.

Parts and O-rings

First impressions and features

When I came to this RTA I I was very impressed by the performance and quality of it. A gold was only an impressive finish to it. The thread and O-rings are very good. No O-ring damage or sticking to the glass dismount. air flow by using three separate holes instead of a large on each side. Ideal for people who want to lose air. It is a little tight, but and it can be difficult to adjust in the mod.

Deck Construction (photos above)

Let us now build a platform. It is rather the style and pace of the second holes after 2 bridge by mail, but with more metal in it. Each cable has the hole itself was always good and is easy to build one. Hexagonal use good quality accommodation which is my favorite. It also has some extra metal between coils with a hole. conditioned air flow is downwards with two relatively small holes in the bottom of each coil. platform is very easy to align your reel in the airflow, but do not have a lot of space in it. It is more appropriate to reduce the power of smaller construction. I found 3 mm max be fit there and 2.5 mm also works very well. Generally easy to build a platform made by a small construction

It is also easy to capillarity. This is a platform GTA style is really very low. No JFC and leak. It was pretty forgiving, but if you use a lot of cotton. Not too accelerator, but sufficient to fill every slot with a flush cotton tip at the bottom. You should be able to adjust its pincers easily between cotton and fill holes that are small enough. I found the coil 2.5 mm is not necessary to your potential customers thin at all. The son of 3mm want to roll clarify a bit.

success

Regarding performance, the use as a double coil RTA only as intended. I found three coil construction luxury through it in the range of 5 to 6 packs 3 mm and 2.5 mm ID. I also found 2 rounds of simple construction with 26 envelopes measuring instruments 8-9 Nichrome 1 mm ID 3 and 1 in the 2.5 mm ID. Overall, I think it works well with everyone to build. It is very flexible and does not need anything fancy to taste good, but I would stick with either 3 mm internal diameter of 2.5 mm in diameter or ID of the coil. There is plenty of room for a large building, it is best used in the range of 40-70 watts. It would not take much more than that. That said, I have a very good sense. This figure is higher than the average watts average TSR. I feel I’ve done the best construction for taste is luxurious 5 reel within 2.5 mm film DI TC 60 watts.

general impressions, details and extras

This is the bottom of the RTA and AFC airflow is smooth, but a little tight and cover. glass bubble, it is difficult to adjust when I was in the Ministry of Defense, but easy to adjust when mod. Full level is high where the lid is unscrewed and expose two holes filling large. hat has a textured design as well and is easy to grip and open the cover. It is easy to fill all kinds of bottles or juice simply poured. I used the 70/30, 80/20 and juice “VG max” on it without problem. 810 comes with a standard tumble blanket Ultem and wrote on it. It is very good and easy to disassemble, with a minimum of parts to it. All nice and soft yarn. Is the diameter of 24mm RTA therefore does not harm most mods. capacity of 4.5 ml is pretty good with a glass bubble for tanks that do not really drink juice.

Pro:

manufacturing quality

visible

Colour selection

standard tip 810

build a bridge and posts good quality screws

filling marquee design

above the average of the direction RTA mid watts

capacity 4.5 ml

Drawbacks:

It build a platform is limited to the size of the coil

AFC difficult to adjust when mod

conclusion

So with all that said, I recommend the RTA? I do not like or is not difficult, but will lean slightly toward him, but with a caveat was added to the average vapers watts. If you want to vape more than 70 watts it is not for you. If you want VAPE 40-70 watts and does not touch the juice and still get a good sense, it is a very good choice. Not going to do my best, but still good enough prey RTA. I’ll add to my list

You can buy here Manta 24mm TSR Advken | Staggered two Design Post in 32.95

It was Anthony fried Keep only honest, I hope you all can say the same and I’ll catch the next revision.

For a good recommendation Google see my resume is here

This sheet is updated regularly so feel a marker.

Once again I want to thank you for sending me this elementvape.com for the purposes of this review

Also, if you missed some of my previous comments you can be found here Save Me

 

Leave a Reply

Your email address will not be published. Required fields are marked *